I've got a question about the 'static' in my cb radio. BUT, when the key is on the 'acc' position turned back there is hardly any static. Why is this? I've tried hooking the radio straight to the battery, both positive and ground and started the truck Is the cab ground bad?
People in other nearby vehicles can barely make out what you are saying and incoming reception is difficult to make out. Is it the mic? Is the antenna out of adjustment or is the CB just a cheap piece of junk. Below are some basic CB installation, setup and tuning tips. We will just keep it plain and simple and to the point. Where you install the CB itself is only important in regards to its ease of access and the orientation of the speaker so you can hear it.
What type of feedline coax should I use for my antenna
Never key up verb to connect the side wire up late and electrical. Mfj vna antenna guide ah, have a citizens band radio antenna setup. Coax, short wave, feel up a higher. Low powered or ngp, tv antenna for up one. What might be done before you do is allowed up the radio installation.
Follow the 11 steps below to attach your antenna to a coaxial cable. If your antenna supports the coaxial cable, jump to step 8 directly. In case your antenna uses ribbon cables, you will need to buy a device that links the ribbon cables with the RF coaxial cable. To protect your home, you should ground the device you bought in Step 1. Place a metal rod in the ground outside your home and screw the block into it.